Extracting method of typical shape defect vector for super-wide strip steelChinese Full Text
YANG Guang-hui;ZHANG Jie;LI Hong-bo;YAN Qin-tai;JIA Sheng-hui;CHU Yu-gang;School of Mechanical Engineering,University of Science and Technology Beijing;Cold Rolling Plant,Wuhan Iron ＆ Steel (Group) Corporation;
Abstract: This article introduces a method of extracting the typical defect vector of strip shape. In the method,firstly the strip shape defects are primarily classified,then the unit typical strip shape vector is extracted according to similarity among strip stresses, and finally the typical ratio coefficient is solved with the k-means cluster approach. Aiming at the unit typical strip shape vector extracted,a taper work roll was designed and put into a large-scale trial. It is shown that the shape quality of rolled strips is better than before. The comprehensive flatness is below 5 IU,and side and middle composite buckles are basically eliminated.
- DOI：
10.13374/j.issn1001-053x.2014.04.015
- Series：
- Subject：
- Classification Code：
TG335.12
- Mobile Reading
Read on your phone instantly
Step 1Scan QR Codes
"Mobile CNKI-CNKI Express" App
Step 2Open“CNKI Express”
and click the scan icon in the upper left corner of the homepage.
Step 3
Scan QR Codes
Read this article on your phone.
- HTML
- CAJ Download
- PDF Download
Download the mobile appuse the app to scan this coderead the article.
Tips: Please download CAJViewer to view CAJ format full text.
Download: 179 Page: 523-528 Pagecount: 6 Size: 475K
Citation Network
Related Literature
- Similar Article
- Reader Recommendation
- Associated Author